ATO Interpretative Decision

ATO ID 2011/48

Excise

Excise and the number of premises specified in a licence to manufacture
FOI status: may be released

CAUTION: This is an edited and summarised record of a Tax Office decision. This record is not published as a form of advice. It is being made available for your inspection to meet FOI requirements, because it may be used by an officer in making another decision.

This ATOID provides you with the following level of protection:

If you reasonably apply this decision in good faith to your own circumstances (which are not materially different from those described in the decision), and the decision is later found to be incorrect you will not be liable to pay any penalty or interest. However, you will be required to pay any underpaid tax (or repay any over-claimed credit, grant or benefit), provided the time limits under the law allow it. If you do intend to apply this decision to your own circumstances, you will need to ensure that the relevant provisions referred to in the decision have not been amended or repealed. You may wish to obtain further advice from the Tax Office or from a professional adviser.

Issue

Can a licence to manufacture excisable goods issued under the Excise Act 1901 (Excise Act) specify multiple premises?

Decision

Yes, a licence to manufacture excisable goods issued under the Excise Act can specify multiple premises.

Facts

An entity applies for a licence to manufacture excisable goods at three premises.

The entity will undertake a process of manufacturing of particular excisable goods at these different locations.

Reasons for Decision

By the operation of section 25 of the Excise Act, a person is required to hold a licence to manufacture excisable goods. Section 27 of the Excise Act stipulates that the excisable goods may only be manufactured at the premises specified in the licence.

Sections 39 and 39A of the Excise Act deal with the application for, and the granting of a licence respectively.

Section 39 of the Excise Act provides that an application may be made for a licence, and in particular paragraph 39(2)(d) states in part that the application must 'contain a description of the premises in relation to which the licence is sought'.

The term 'premises' is not defined in the Excise Act and therefore takes its ordinary meaning. The Australian Oxford Dictionary, 2004, rev. 2nd edn, Oxford University Press, Melbourne defines 'premises', when used in plural, as

2 (in pl.) a a house or building with its grounds and appurtenances, b Law houses, lands, or tenements previously specified in a document etc.

Hence, when adopting the ordinary meaning of 'premises' in the context of a licence issued under the Excise Act, the word means the buildings and lands that are specified in the licence.

This does not clarify whether a manufacturer licence may specify premises that are at more than one separately identifiable location.

Subsection 39A(1) of the Excise Act gives the discretion to the Commissioner to grant, or refuse to grant the licence. Without limiting the operation of subsection 39A(1), subsection 39A(2) of the Excise Act includes matters on which the Commissioner may refuse to grant a licence. Relevantly, subsection 39A(2) includes the following:

...
(g) in relation to an application for a manufacturer licence...the physical security of the premises in relation to which the licence is sought is not adequate having regard to:

(i)
the nature of the premises; or
(ii)
the kinds and quantity of goods that would be kept at the premises; or
(iii)
the procedures and methods that would be adopted by the applicant to ensure the security of goods at the premises

...

The Excise Act does not state that only one location may be cited when a premises is specified in a manufacturer licence. It merely states the premises must be specified, and that the Commissioner, in exercising the discretion to grant a manufacture licence, may give consideration to the premises and matters directly related to the premises.

The Acts Interpretation Act 1901 provides, at section 23, the rules as to gender and number in the interpretation of statute and states:

In any Act, unless the contrary intention appears:
...
(b) words in the singular number include the plural and words in the plural number include the singular.

As the Excise Act does not explicitly state that only premises at a single location may be specified in a manufacturer licence, it is considered that premises at more than one location may be specified in a manufacturer licence.

Date of decision:  3 June 2011

Legislative References:
Excise Act 1901
   section 25
   section 27
   section 39
   section 39A
   subsection 39A(1)
   subsection 39A(2)
   paragraph 39(2)(d)

Acts Interpretation Act 1901
   section 23

Other References:
The Australian Oxford Dictionary, 2004, rev. 2nd edn, Oxford University Press, Melbourne

Keywords
Excise
Statutory licences
Licensed premises

Siebel/TDMS Reference Number:  1-2LN62P8

Business Line:  Indirect Tax

Date of publication:  10 June 2011

ISSN: 1445-2782